Type "git clone -recursive git:///urjaman/frser-duino" without quotations and press enterĨ.
Reflash hp 15 f272wm bios with spi programmer install#
Type "sudo apt-get install flashrom gcc-avr binutils-avr gdb-avr avr-libc avrdude git" without quotations and press enterħ.
To get the necessary software (flashrom, frser-duino) required for flashing the new bios, press the top icon on the taskbar, type "Terminal" and click the Terminal iconĦ.
Check Enable USB Controller, select the speed of your USB port (1.0,2.0 or 3.0) and Add a new USB filter for the connected Arduinoĥ. Close Ubuntu down and go to the USB settings in VirtualBoxģ. On working system, install Ubuntu through VirtualBox using this guide BUT also install USB drivers where it says not to!Ģ. ROM file (usually under c:\SWSetup\ )and copy to a USBġ. v8.17 for me) and after double clicking the exe, find the extracted. Download the latest BIOS for your PC by googling HP drivers and your PC model (eg. Jumper leads to attach to the Arduino and SPI header like these Arduino Uno R3 (I used a Freetronics Eleven R3) A broken HP system (ours is a HP ENVY 23- d113a TouchSmart All-in-One Desktop PC) The following is what worked for me, however YMMV - attempt at your own risk and only as a last resort. None of these solutions worked, so I went with drastic measures and attempted a BIOS reflash using the ROM_RECOVERY SPI header. Changed CMOS reset jumper as per instructions around 35-40 times (left overnight to dissipate charge) Here it is if anyone still needs it:Īfter half a week of trying, I've finally got the system up and running again!Īfter countless hours of googling, piecing information together and nail-biting experimentation, I was able to successfully flash the latest BIOS using a similar method to PhoenixForce.
For some reason my original post was deleted.